Suchergebnisse

Hm, neuer Kanal 🤔 UniFi Access Point 6.6.24https://community.ui.com/relea…32-44d9-9539-0174283b20e0 Improvements Eliminated client connectivity downtime when configuring SNMP, NTP, minimum rate, and toggling Debug Logging.Improved overall stability by fixing kernel crashes.[Gen4/Gen5] Improved RSSI calculation to increase minimum RSSI accuracy.[Gen6] Improved range by increasing maximum TX power in FCC countries.[U6+/U6LR+] Improved 2.4GHz latency.Bugfixes Fixed band steering occasionally not st…

UniFi Access Point 6.6.26https://community.ui.com/relea…a6-411e-b271-e498265aaa4c Improvements Added 6GHz support for Australia and Japan.[Gen6] Improved overall performance and latency.Bugfixes Fixed kernel crashes to improve stability.[Gen5] Fixed APs rebooting when clients reconnect to a WPA3 WLAN after a reboot/firmware update. This was introduced in 6.6.24.[U6-LR] Fixed 2.4GHz radio randomly stops broadcasting. This was a race condition and occurs rarely.Known issues [Gen6] Tx and Rx rates …

Hast du ne Enterprise für 6E? Denke eher nicht. Wifi 6 hat erstmal kein 6GHz, erst 6E und das kann nur der Enterprise

UniFi Access Point 6.6.27https://community.ui.com/relea…54-47cf-9c15-34e9db57bbae Bugfixes Fixed kernel crashes to improve overall stability.[UAP-Gen4] Fixed intermittent 2.4GHz connectivity issues observed by some users (`MgmtRingFullCount` in log).[UAP-Gen6] Fixed AP state sometimes transitioning to 'Offline' in NET after a configuration change that forces a full provision, needing a power cycle to recover.[UAP-Gen6] Fixed Tx and Rx rates not being reported for connected clients. This was intr…

Schneller als die Polizei erlaubt

UniFi Access Point 6.6.31https://community.ui.com/relea…40-4cc3-a789-4bf275ef3963 Improvements [Gen4/Gen5] Ensure APs pick a non-DFS channel after a radar hit on a DFS channel.Bugfixes Fixed inform URL not updating if the AP management subnet is changed, leading to the AP going Offline in NET until set-inform is issued again.Fixed devices rarely going into an Adoption Failed state in the Network Application after a firmware update.Fixed kernel crashes to improve overall stability.[Gen2/Gen3/Gen6…

UniFi Access Point 6.6.32https://community.ui.com/relea…57-45d8-9440-177c7b8d9614 Improvements [Gen6] Improve firmware update resiliency.Bugfixes [Gen2/Gen3/Gen6] Fixed APs rarely not broadcasting at 5GHz when the channel configuration is changed to a DFS channel.[Gen2/Gen3/Gen6] Fixed RF Scan not working when outdoor mode is enabled.[Gen6] Fixed channel interference being reported incorrectly in very clean environments (`invalid stat cu_interf: -1` in logs). This was introduced in 6.6.27.[Gen6]…

Womöglich benötigen sie ein wenig Zeit für Frequenz Scannen und stabilisieren sich.

UniFi Access Point 6.6.33https://community.ui.com/relea…ca-4c57-9b78-f6408cb0712a Bugfixes Fixed BLE bridge not working in some cases (specifically when the AP and Protect Console are on different subnets). This would cause UP-Sense devices to go offline.[UAP-Gen4] Fixed intermittent 2.4GHz connectivity issues observed by some users (`MgmtRingFullCount` in log).[Gen4/Gen5] Fixed AP not scanning for cleaner channels (Auto Channel Scan) when the configured channel width is changed and the channel …

UniFi Access Point 6.6.35https://community.ui.com/relea…59-4c18-8566-0fa9042802cd Improvements Improved wireless uplink candidate selection when multiple uplinks are available.[Gen4/Gen5] Improved firmware update and adoption resiliency.[U6-Enterprise/U6-Enterprise-IW] Added 6GHz support for Latvia and New Zealand.[U6+/U6LR+] Fixed incorrect basic rates being advertised in 2.4GHz beacons when a minimum data rate of 12 Mbps is configured.Bugfixes Fixed EAP authentication failing in some cases wit…

Das mit 6GHz freischalten auf Gen 6 hat Klärungsbedarf??!! UniFi Access Point 6.6.36https://community.ui.com/relea…f0-4391-8f27-6d9666496a8c OverviewUniFi Access Point 6.6.36 adds 6GHz support to several new countries that have adopted the WiFi6E standard. It's only available for Gen6 Access Points. Improvements Added 6GHz support to several new countries that have adopted the WiFi6E standard.Fixed incorrect channels being used in outdoor mode.Improved firmware update resiliency.Improved overall…

Kurt-oe1kyw Ne das ist klar. Nur da steht auf Gen6.....ist der U6 Pro ein gen5 oder 6? Wäre er ein Gen6 würde er 6GHz bekommen? Steht so nicht in den Specs.

UniFi Access Point 6.6.38https://community.ui.com/relea…8e-4a4c-bfd1-c5f7d74385d3 Bugfixes Fixed kernel crashes to improve overall stability.[Gen4] Fixed incorrect country beacon IE being advertised for Belgium.[U6-Enterprise-IW] Fixed reset button not working. This was introduced in 6.6.x.[U6-IW/U6-Enterprise-IW] Fixed a large number of clients being reported as connected to the 'PoE In + Data' port when meshing is disabled in System Settings.Additional information Refer to the Help Center arti…

UniFi Access Point 6.6.41https://community.ui.com/relea…35-48ca-a9f9-96b2bcfabf74 Improvements Improved configuration resiliency to avoid APs going Offline after a firmware update/adoption in very rare cases, requiring a power cycle to recover.[Gen3] Improved stability by fixing kernel crashes.Bugfixes Fixed PPSK VLAN not working when the same VLAN ID is being used for another WLAN.Fixed PPSK VLAN assignment not working after roaming between APs.[Gen4] Fixed 5GHz radio not beaconing on a DFS cha…

UniFi Access Point 6.6.42 https://community.ui.com/relea…7c-4096-a6f1-c4125ef4a004 Improvements Improved overall stability by fixing kernel crashes.Bugfixes [Gen2] Fixed broken 5GHz client connectivity, introduced in 6.6.39.Additional information Refer to the Help Center article here to determine the UniFi Access Point generation.Update your devices by changing the Device Firmware Release Channel in the UniFi Network application to Early Access.If you wish to go back to the Official release afte…

UniFi Access Point 6.6.43https://community.ui.com/relea…77-4d70-b177-93ebc818d383 Improvements [Gen4] Improved wireless adoption resiliency.Bugfixes Fixed log spam on configuration changes (local: not in a function) introduced in 6.6.39.Additional information Refer to the Help Center article here to determine the UniFi Access Point generation.Update your devices by changing the Device Firmware Release Channel in the UniFi Network application to Early Access.If you wish to go back to the Official…

UniFi Access Point 6.6.46https://community.ui.com/relea…f5-494d-a1f0-8056684b5bc8 Improvements [Gen4/Gen5] Improved overall stability by fixing kernel crashes.Bugfixes [Gen2/Gen3/Gen6] Fixed clients getting kicked by the AP occasionally, leading to poor connectivity. This was introduced in 6.6.21.[U6-LR] Fixed AP occasionally getting stuck on a firmware update, requiring a power cycle to recover.Additional information Refer to the Help Center article here to determine the UniFi Access Point gene…

UniFi Access Point 6.6.49https://community.ui.com/relea…07-4614-a2bc-4692aecd471b Improvements [U6+] Improve overall stability by fixing kernel crashes.Bugfixes Fixed APs rarely going into an Adoption Failed state after a firmware update.[Gen2] Fixed incorrect VLAN assignment after roaming with PPSK.[Gen2] Fixed AP showing up for adoption before getting a valid IP. If the AP was adopted in this state, it would temporarily get stuck in an Adoption Failed state.[U6-Enterprise-IW] Fixed uplink port…

UniFi Access Point 6.6.51https://community.ui.com/relea…1f-4599-bbe6-dd90785ab675 Improvements Improved stability and performance.Improved band steering logic to prevent client connection bouncing between 2.4 GHz and 5 GHz.Bugfixes [Gen2] Fixed spontaneous reboots occurring sometimes in extremely busy environments (Interference Detected in logs prior to reboot). This was introduced in 6.6.20.[Gen4/Gen5] Fixed indoor-only channels potentially being used when outdoor mode is enabled and radio chan…

UniFi Access Point 6.6.54https://community.ui.com/relea…c5-4656-a651-7dca0de33f52 Improvements [Gen4/Gen5] Improved stability by fixing kernel crashes.[Gen6] Improved throughput on PPSK and RADIUS-assigned VLAN SSIDs for untagged clients when no VLAN-tagged clients are connected.Bugfixes Fixed lower than expected Wireless Experience Score with certain IoT devices that was not observed with 6.5.x. This was introduced in 6.6.33.Fixed APs rarely going into an Adoption Failed state after a firmware …